BMR Suspension Coil Spring / Tie Rod Sleeve / Stabilizer Bar Kit - SB054R

The two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR's suspensions SB054 rear sway bar was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, and adjustability requirements. Manufactured from heavy-duty 1.25-inch DOM steel tubing, the SB054 is cold formed to better resist torsional fatigue and retain its "memory" far longer than the hot-formed bars used by many competitors. The sway bar is CNC-formed for exact manufacturing tolerances and repeatable high quality. The SB054 attaches to your 2016-newer Camaro with 95-durometer polyurethane bushings, reducing the deflection from the stock rubber bushings. These bushings are molded from 95-durometer, low-deflection, polyurethane, and are internally fluted to keep grease in the bushing.BMR's suspension designed the SB054 sway bar for street performance, autocross, and road race applications. The three-way adjustable SB054 gives you a 73%-125% increase in rate over the stock bar. The rate increases gives you improved handling characteristics so you can drive harder through corners with minimal body roll. This allows for more sway bar control, which equals better handling. When performance is a must, rely on BMR's suspension!BMR's suspensions SB054 sway bars are available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 1-2 hours. Proudly made in the U.S.A.!Does Not Fit Convertible Cars

Note: Fits 2016-Newer Chevrolet Camaro(excluding cars with ELSD);Designed for street performance, autocross, and road race applications;Dramatically reduces body roll;52%-198% increase is sway bar rate over stock sway bar;Cold formed to better resist torsional fatigue;Manufactured from 1.25-inch heavy-wall DOM tubing for increased strength;88-durometer, greaseable polyurethane bushings;Zinc-plated inner sleeves;Durable powdercoat finish;1-2 hour installation time;Proudly designed in the U.S.A.;Proudly made in the U.S.A.